| Because the garage is usually built attached to the | | | | Measure where you’ll be mounting the weather |
| home, the cool air generated from the air conditioner | | | | strip by lifting the garage door up to the chest level. |
| may leak through gaps around the garage door. The | | | | This way you can have a proper look and adjust the |
| garage door weather strip will keep air from leaking | | | | strip to the proper position. Mark it with a mark tape or |
| out, making the garage warmer in winter and cooler in | | | | a clamp. Unroll the strip and make sure the length is |
| summer. Besides conserving energy, it can help | | | | about the right size. While positioning the strip, make |
| keeping the garage clean. No longer do you have to | | | | sure that its overhang doesn’t extend to the |
| worry about water entering the garage because this | | | | outside. If it does so, the extension would hit against |
| weather strip will prevent any incoming rain, snow, dirt, | | | | the garage doorframe and you may end up spending |
| snakes and rodents from entering underneath the | | | | time trimming it. |
| doors. Installation of a garage door weather strip is | | | | |
| very easy which even un-handymen and women can | | | | Now you are ready and prepared for the installation, |
| perform. | | | | line the weather strip up with both ends past the door. |
| | | | | Put a staple to the strip. Keep stapling across the |
| Make sure garage weather strip as straight as | | | | entire strip, skipping every 3 inches or so. When you |
| possible and that the floor is clean and completely | | | | are finished stapling, check both ends and trim the |
| dry. At you can get the whole kit to make this an | | | | weather strip to make sure it meets the end of the |
| easy and quick installation. The whole kit comes with | | | | door. After you have completed this, alleviate the |
| a lifetime warranty as well. | | | | garage door for easy hammering. Make sure there |
| | | | | are no nails left from the previous installation on the |
| If a weather strip was previously mounted, remove the | | | | floor. Now attach the strip to the bottom roller bracket |
| old seal and its staples. If those staples cannot be | | | | and hammer via the holes measurable during an earlier |
| removed, hammer to flush them into the floor. The | | | | process. At you can easily find the whole kit and get |
| point is to have the floor as smooth as possible so the | | | | started immediately. The Tsunami Seal® Garage |
| new weather door strip won’t get torn. Before | | | | Door Threshold works with any garage door such as |
| moving on be aware that the amount of moisture | | | | roll up doors, hinged wooden doors, and walk-through |
| accumulated on the weather strip can afflict rot on the | | | | doors and comes in black, gray and brown to match |
| bottom of the door. This can be prevented by coating | | | | the color scheme of your home. Keep your garage |
| the door bottom with a clear wood preservative. | | | | clean and cut your cost in energy bills. I am very sure |
| | | | | you will be happy with the results. |